<HTML>
<HEAD>
<TITLE>Re: [Paraview] comparing z= constant planes</TITLE>
</HEAD>
<BODY>
<FONT FACE="Calibri, Verdana, Helvetica, Arial"><SPAN STYLE='font-size:11pt'>You can translate the output of the slice filter in the Z direction (or any other direction) using the Transform filter.<BR>
<BR>
-Ken<BR>
<BR>
<BR>
On 11/28/08 8:20 AM, "Stephen Wornom" <<a href="stephen.wornom@sophia.inria.fr">stephen.wornom@sophia.inria.fr</a>> wrote:<BR>
<BR>
</SPAN></FONT><BLOCKQUOTE><FONT FACE="Calibri, Verdana, Helvetica, Arial"><SPAN STYLE='font-size:11pt'>I have to parallel planes offset by a constant z. I slice twice to get<BR>
the two planes, z1 and z2 (z2= z1+ conste).<BR>
I would like to overlay the wire frames (remove the z-offset from plane<BR>
z2), how does one do this?<BR>
Stephen<BR>
<BR>
--<BR>
<a href="stephen.wornom@sophia.inria.fr">stephen.wornom@sophia.inria.fr</a><BR>
2004 route des lucioles - BP93<BR>
Sophia Antipolis<BR>
06902 CEDEX<BR>
<BR>
Tel: 04 92 38 50 54<BR>
Fax: 04 97 15 53 51<BR>
<BR>
<BR>
</SPAN></FONT></BLOCKQUOTE><FONT FACE="Calibri, Verdana, Helvetica, Arial"><SPAN STYLE='font-size:11pt'><BR>
</SPAN></FONT><FONT SIZE="1"><FONT FACE="Monaco, Courier New"><SPAN STYLE='font-size:7.5pt'><BR>
**** Kenneth Moreland<BR>
*** Sandia National Laboratories<BR>
*********** <BR>
*** *** *** email: <a href="kmorel@sandia.gov">kmorel@sandia.gov</a><BR>
** *** ** phone: (505) 844-8919<BR>
*** web: <a href="http://www.cs.unm.edu/~kmorel">http://www.cs.unm.edu/~kmorel</a><BR>
</SPAN></FONT></FONT><FONT FACE="Calibri, Verdana, Helvetica, Arial"><SPAN STYLE='font-size:11pt'><BR>
</SPAN></FONT>
</BODY>
</HTML>