<p>Are you adding the resource file in your CMakeLists.txt?</p>
<p>Regards,<br>
Paul</p>
<p><blockquote type="cite">On Feb 4, 2010 9:31 PM, "Michael Jackson" <<a href="mailto:mike.jackson@bluequartz.net">mike.jackson@bluequartz.net</a>> wrote:<br><br>I am developing a custom panel for a vtkFilter that I wrote. As part of the GUI, I need to load up a jpg image to use as an icon in the GUI. I put an entry into the .qrc file where the entry for the .ui file is located but when I load the panel the image does not show up. I don't get any type of error either so I am not really sure where to start hunting this down.<br>
<br>
Anyone have any ideas?<br>
___________________________________________________________<br>
Mike Jackson <a href="http://www.bluequartz.net" target="_blank">www.bluequartz.net</a><br>
Principal Software Engineer <a href="mailto:mike.jackson@bluequartz.net" target="_blank">mike.jackson@bluequartz.net</a><br>
BlueQuartz Software Dayton, Ohio<br>
<br>
<br>
_______________________________________________<br>
Powered by <a href="http://www.kitware.com" target="_blank">www.kitware.com</a><br>
<br>
Visit other Kitware open-source projects at <a href="http://www.kitware.com/opensource/opensource.html" target="_blank">http://www.kitware.com/opensource/opensource.html</a><br>
<br>
Please keep messages on-topic and check the ParaView Wiki at: <a href="http://paraview.org/Wiki/ParaView" target="_blank">http://paraview.org/Wiki/ParaView</a><br>
<br>
Follow this link to subscribe/unsubscribe:<br>
<a href="http://www.paraview.org/mailman/listinfo/paraview" target="_blank">http://www.paraview.org/mailman/listinfo/paraview</a><br>
</blockquote></p>