[Paraview] Ghost data in parallel formats

[Berk Geveci]

Great. Ping me in a 2-3 months - we should have started making changes
to the ghost level stuff by then. Until then, you should be able to
use D3 to redistribute data and generate (cell) ghost levels as
needed. So the following should work

reader -> D3 -> extract surface

-berk

On Tue, Mar 1, 2011 at 10:57 AM, Renato Elias <rnelias at gmail.com> wrote:
>> Berk: Do you have the ability to mark a node as "owned" by one partition
>> and as "ghost" on
>> other partitions?
> Yes! We classify processes as master and slaves according to their ranking
> numbers. After this we can assign the shared node to a master (which will
> take care of shared computations) and tell the slave process that this node
> is being shared with a master (and the slave process will consider it as a
> "ghost" for computations).
> The ideas we used in our parallel solver were taken from the following
> article:
> Karanam, A. K., Jansen, K. E. and Whitinig, C. H., "Geometry Based
> Pre-processor for Parallel Fluid Dynamic Simulations Using a Hierarchical
> Basis", Engineering with Computers (24):17-26, 2008.
> This article was made available from the author
> in http://www.scorec.rpi.edu/REPORTS/2007-3.pdf (Figures 7 to 9 explain the
> communication method between processes),
> Regards
> Renato.
>
> On Tue, Mar 1, 2011 at 12:24 PM, Berk Geveci <berk.geveci at kitware.com>
> wrote:
>>
>> Hi Renato,
>>
>> > I think I'm missing something.... you said cells only?!
>> > If I understood this subject correctly, a cell should be considered
>> > ghost if
>> > it's held by more than one partition/process, isn't it?! In this case,
>> > there'll be an overlapped layer of elements. The problem is that my MPI
>> > solver does not make use of this overlapped layer of cells/elements.
>>
>> Yep. You understood correctly. Ghost cells are very common for finite
>> difference calculations but not as common for finite elements.
>>
>> > It only
>> > has nodes/points that are shared by processes. This explains why I asked
>> > by
>> > a ghost node (shared node would be more appropriated to define such kind
>> > of
>> > node).
>> > Can I consider a cell as ghost if it touches the parallel interface
>> > (without
>> > overlapping)? Would it work?
>>
>> Nope. Then you'd start seeing gaps. The right thing to do is for
>> ParaView to support ghost points (nodes) better. However, this is
>> non-trivial in some cases. For removing internal interfaces, it is
>> sufficient to mark points as ghosts. However, for accurately
>> performing statistics, you need to make sure that you count all points
>> only once, which requires assigning ghost nodes to processes. So a
>> replicated node would be marked as ghost (a better word is shared) and
>> also owned by a particular process. We are going to improve VTK's
>> ghost level support. This is something we'll support. However, it will
>> be up to the simulation to produce the write output. Do you have the
>> ability to mark a node as "owned" by one partition and as "ghost" on
>> other partitions?
>>
>> Best,
>> -berk
>
>
>
> --
> Renato N. Elias
> =============================================
> Professor at Technology and Multilanguage Department (DTL)
> Federal Rural University of Rio de Janeiro (UFRRJ)
> Nova Iguaçu, RJ - Brazil
> =============================================
> Researcher at High Performance Computing Center (NACAD)
> Federal University of Rio de Janeiro (UFRJ)
> Rio de Janeiro, Brazil
>
>