[Paraview] Switching time steps when running parallel

[Stief, Alexander]

I am using the ensight gold file format for transient results.
When running Paraview in parallel mode (Auto MPI), I am unable to load any time step except the first one.
Trying to load a different time step results in the error message:


ERROR: In /home/buildslave/dashboards/buildbot/paraview-pvbinsdash-linux-shared-release_opengl2_qt4_superbuild/source-paraview/ParaViewCore/VTKExtensions/Default/vtkPEnSightReader.cxx, line 343
vtkPEnSightGoldBinaryReader (0x30d9510): error reading geometry file ../ModelEnsight/LB_results.geo 0

ERROR: In /home/buildslave/dashboards/buildbot/paraview-pvbinsdash-linux-shared-release_opengl2_qt4_superbuild/source-paraview/VTK/Common/ExecutionModel/vtkExecutive.cxx, line 784
vtkCompositeDataPipeline (0x30d8f40): Algorithm vtkPEnSightGoldBinaryReader(0x30d9510) returned failure for request: vtkInformation (0x31fc9a0)
  Debug: Off
  Modified Time: 96520
  Reference Count: 1
  Registered Events: (none)
  Request: REQUEST_DATA
  ALGORITHM_AFTER_FORWARD: 1
  FORWARD_DIRECTION: 0
  FROM_OUTPUT_PORT: 0


When I try the same without Auto MPI enabled it works perfectly. It is just that I would like to use Auto MPI because it speeds up the filters a lot.
I tried with versions 5.2.0 and 5.3.0.

Regards
Alex
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://public.kitware.com/pipermail/paraview/attachments/20170328/ecc1eccc/attachment.html>