[Paraview] Tecplot Reader issue

[Adriano Gagliardi]

Dear All,

I've been trying to read in a Tecplot ASCII file containing data of type
FELINESEG, but the ParaView reader doesn't seem to recognise it. It reads
fine into Tecplot itself. The header I'm using is:

TITLE = "temp"
VARIABLES = "X", "Y", "Z" "cp"
ZONE T="CUT1", DATAPACKING=POINT, NODES=2, ELEMENTS=1, ZONETYPE=FELINESEG
0.0 0.0 0.0 0.5
1.0 0.0 0.0 1.0
1 2

This is an example, but it should read in fine. The Tecplot reader I'm using
is from a November/December CVS snapshot, so I could be using an out-of-date
version. It would be useful if someone could confirm whether this problem
still exists in newer releases.

Thanks in advance.

Cheers,

Adriano


===================================

Adriano Gagliardi MEng PhD
Project Scientist
Computational Aerodynamics
Aircraft Research Association Ltd.
Manton Lane
Bedford

Tel: 01234 32 4644
E-mail: agagliardi at ara.co.uk
Url: www.ara.co.uk 


---------------------------
This email contains information that is private and confidential and is intended only for the addressee.  If you are not the intended recipient please delete it and notify us immediately by e-mailing the sender.
Note: All email sent to or from this address may be accessed by someone other than the recipient, for system management and security reasons.
Aircraft Research Association Ltd.  Registered in England, Registration No 503668 Registered Office: Manton Lane, Bedford MK41 7PF England VAT No GB 196351245